Posted in NX CR 2206

Scale Body in NX

You can scale solid bodies or sheet bodies by using the “Scale Body” command in NX Modeling. Home Ribbon Bar => Base Group => More Drop down arrow =>

Continue Reading Scale Body in NX
Posted in NX CR 2206

Trimming Body on the Boolean Operation

When you combine two or more bodies by using the “Unite” command you can remove selected regions of the bodies. To trim bodies when combining bodies: Start the

Continue Reading Trimming Body on the Boolean Operation
Posted in NX CR 2206

Deleting Bodies in NX Modeling

You can delete solid bodies by pressing the “Delete” button but if more than one body is created by one operation you can not delete a single body without

Continue Reading Deleting Bodies in NX Modeling
Posted in NX 11

Thread

Thread command, creates a thread on cylindrical faces. (For holes use Hole command. Use thread command only for outer surfaces of the cylinder).

Continue Reading Thread
Posted in NX 11

Delete Body

Delete Body command, deletes one or more bodies in the modeling.

You can activate command by:

Continue Reading Delete Body