You can pattern curves around point by “Circular Pattern” in Pattern Curve command
Change “Layout” as a “Circular” in the
Read More Circular Pattern
Tag: Insert
You can pattern curves through one or two linear directions by “Linear Pattern” in "Pattern Curve" command
Change “Layout” as a
Read More Linear Pattern
Linear Pattern
Pattern Curve is used for patterning curve-curves in the sketch.
Note: If you have a selection problem change curve rule on top bar shown in the figure
Read More Pattern Curve
Pattern Curve
“Divide Face” command is used for dividing faces. (It is currently hidden in Siemens NX 11.) It creates divided faces to extrude face, pull face, to define
Read More Divide Face
Divide Face
You can change hole diameters by using the “Resize Face” command. The circle center stays constant.
Command activation: Click on
Read More Resize Face
Resize Face
Thread command, creates a thread on cylindrical faces. (For holes use Hole command. Use thread command only for outer surfaces of the cylinder).
Read More Thread
Thread
Delete Body command, deletes one or more bodies in the modeling.
You can activate command by:
Read More Delete Body