You can pattern curves to defined points by changing “Layout” as a “General” in the “Pattern Definition” tab.
To make General Pattern:
Read More General Pattern
Tag: Curve from Curves
You can pattern curves around point by “Circular Pattern” in Pattern Curve command
Change “Layout” as a “Circular” in the
Read More Circular Pattern
Circular Pattern
You can pattern curves through one or two linear directions by “Linear Pattern” in "Pattern Curve" command
Change “Layout” as a
Read More Linear Pattern
Linear Pattern
Pattern Curve is used for patterning curve-curves in the sketch.
Note: If you have a selection problem change curve rule on top bar shown in the figure
Read More Pattern Curve
Pattern Curve
Offset Curve command offsets “curves in the sketch” or “edges on model” in sketch application. Offset curves are directly associated with their main curves.
Read More Offset Curve
Offset Curve
Mirror command creates a mirror pattern of curves that lie on the sketch. Mirrored curves are directly associated with their symmetry. All changes on the curve
Read More Mirror Curve