You can create curves on the intersection of the objects. These intersection curves can be created: on the intersection of objects such as surfaces or solid
Read More Creating Intersection Curve in Siemens NX
Tag: curve
You can project curves onto the faces of solid bodies, surfaces, or planes in the Siemens NX Modeling. You can project curves along a vector or along a face
Read More Project Curve to Surface in Siemens NX
Project Curve to Surface in Siemens NX
You can draw freehand curves on the nonplanar surfaces in Siemens NX modeling. The model face works as a sketch zone and the curves that you draw stick on the
Read More Drawing Freehand Curve on Surface in Siemens NX
Drawing Freehand Curve on Surface in Siemens NX
In NX drafting, the created line curves with the same dimension sizes might be seen as different sizes as shown in the figure. This problem occurs because of
Read More Curve Length Problem in NX Drafting
Curve Length Problem in NX Drafting
Linear Pattern is one of the pattern methods in the "Pattern Curve" command. You can pattern the selected curve to the right, left, up, and down sides in the
Read More Linear Pattern in NX Sketch
Linear Pattern in NX Sketch
You can create an offset of the curves at a specified distance in NX Sketch. Also, you can offset objects out of the sketch. (To select outer objects set the
Read More Offset Curve in NX Sketch
Offset Curve in NX Sketch
You can create a fillet between the lines in the NX sketch by using the "Fillet " command in the Home Ribbon Bar. You can fillet connected or unconnected
Read More Creating Fillet in NX sketch
Creating Fillet in NX sketch
The "Arc" command is used to create arcs in the sketch environment in Siemens NX. Also, you can use shortcut
Read More Arc in NX Sketch
Arc in NX Sketch
In NX sketch, you can create simple straight lines by using the "Line" command on the "Home Ribbon Bar". (The figure shows the command location) To create
Read More Line in NX Sketch
Line in NX Sketch
You can create a circle in the NX sketch by using the "Circle" command on the "Home Ribbon Bar" in NX Sketch Environment. The figure shows the Circle icon
Read More Circle Creating in NX Sketch