Fill Surface

You can create a surface from a set of curves or/and edges by filling the region inside the set of curves or/and edges. An only connected set of curves/edges can use to create a surface.

You can not select two regions by using the “Fill surface” command. Only one region can specify to create a surface inside the curve set.

To create a surface by using the “Fill Surface” command:

  1. Start the “Fill Surface” command.
    (Surface Ribbon Bar => Surface Group => Fill Surface)
  2. Select the curves to specify a region.
  3. Click the MMB to finish the command.

Leave a Reply

Your email address will not be published. Required fields are marked *