Creating Point on a Spline Curve in NX

If you create a spline in NX Modeling, you can create points on the spline. The points will be created at the location where the points are used to create a spline.

To create a point set on a spline:

  1. Start the “Point Set” command.
  2. Change the creation method to “Spline Points”.
  3. Select spline
  4. You will see a preview of the points on the curve.
  5. Click on the “OK” button to create points.

Note: This method only works on splines created in NX by using the “Through Points” command.

Leave a Reply

Your email address will not be published. Required fields are marked *